Oil Finishes – Preventing Color Changes Light Woods

If you have ever completed a light colored wood like White Ash with a conventional oil finish, you do not have any doubt been amazed by how much the end can darken the color of the wood. While this color transformation may be for, it might not be pleasing. Lots can be very dark in the can. When a dark oil finish is applied to a brightly colored wood like White Ash, Holly, Beech or Maple, the color of the wood might be significantly darkened or worse yellowed. The solution will help keep your wood truer to its original color and save you money at exactly the exact same time by reducing the quantity of oil finish necessary to attain proper surface build. To stop your oil finish from darkening light colored woods; just seal your job first using a lacquer or shellac sealer, before finishing with your oil.

Oil Finish

Sealing the Bare Wood with Lacquer

This will make a lacquer sealer that will penetrate the wood. This is typically flooded by me before the wood would not take any sealer. Wipe off any excess with paper towels that are and let dry completely or for a few days depending on the weather. When the sealer has dried, cut it back with synthetic wire wool or fine grit sandpaper such as 600-grit or greater. Remove with a tack rag or some air prior to proceeding. Remember to gently cut back the top layer of the oil between coats and eliminate any dust before applying another coat of oil. The amount is dependent upon your preferences clearly explained in the site https://repairart.net/cabot-australian-timber-oil-review and the product. The majority of the oils in my studio need between twenty five and three coats to get the proper build.

Sealing the Bare Wood with Shellac

Denatured alcohol is used for dissolving the flakes. Pour into a glass container; add your flakes and cover. Stir the shellac during the next few days. When all the flakes have melted, stir and strain it or cheesecloth to remove any impurities. If flakes are not purchased by you, make certain before using it to de-wax your own shellac. To do so, choose the shellac that is strained and let it sit for a few days to settle out. You will discover that there formed has a layer at the base of the glass, this is the wax. Decant the Shellac that is over the wax. The remaining Shellac is good for at least three months if kept in a container with a tight fitting lid. Allow the thing that is sealed to dry for a few days and then cut back with cable wood or abrasives. Until the appropriate build is attained apply the oil end in light coats. Always allow the piece dry overnight between coats of oil and cut back the surface with wire wool or abrasives.